INTENSE/STS Remote Mounted Turbo Kit

INTENSE recently became an official distributor for Squires Turbo Systems, commonly referred to as STS. This company pioneered the remote-mounted turbo and holds the patent for it. Just like INTENSE they are a true innovator and the quality of their kits is top-notch. We are proud to be able to offer you this kit in conjunction with them. INTENSE worked long and hard to come up with the proper pipes, pipe routing, dimensions, and under hood work to make this the easiest, cleanest and best performing bolt on turbo kit available for the 3800 community. While the current solution is only ready for N/A :L36/L26 w-bodies other applications will quickly follow.

Our prototype entry level kit increased a stock 2002 Grand Prix GT from 166 to 268 WHP, for a net gain of 102 WHP or 127 crankshaft horsepower. This was done with a base setting of 9 pounds of boost. In round numbers, each pound of turbocharged boost added to the stock L36 engine produced a gain of 11 WHP, or 14 crankshaft horsepower. Higher octane fuel, an intercooler, and better flowing heads and cam will all allow the boost to be turned up, which will in turn produce significantly more power.

Unlike other turbo kits currently available for the 3800, our kit shows strong ramp up, and sustained power through the entire powerband. Our dyno charts show it does not peak and fall off but rather hits peak power and stays there through the entire gear. Dyno charts from other kits on the market show a high peak at 296 WHP and then a rapid fall off. Their charts show a drop of almost 20 whp in only 350 rpm and a continuing loss of power through their entire pull. By contrast, our kits aren’t designed to make the most peak horsepower. Instead they are designed to make the broadest possible powerband. Take a look at our dyno chart and you’ll notice that the powerband is as flat as the state of Kansas. Once the turbo is fully spooled, there is less than a 10 horsepower drop all the way to redline! And for the record, our dyno pulls were done using 93 octane pump gas and with an ambient temperature of 93 degrees.



Click each thumbnail for larger picture.


A remote mounted turbo runs cooler, with no additional lag and requires no major modifications to your vehicle. Installation is easier than with other kits, and the final product makes such a CLEAN underhood and undercar presentation.

The installation is incredibly neat and clean.

Air filter comes with waterproof ‘sock’. Also note oil pump that returns oil to crankcase. A buzzer in the passenger compartment sounds if the pump fails for any reason

No ground clearance is lost! Note: production kits will be mandrel bent stainless steel without all these welds.

Don’t be intimidated. It’s just a tailpipe!

Other benefits of this design include:


Our optional boost controller mounts in the trunk for easy access.


To learn more about these kits, and get any questions you may have answered, check out the very well-written FAQ page from STS.

Right now we’re focusing our efforts on finding the most cost effective ways to get these kits mass-produced. Most likely, we’ll be offering two different kits initially:
And more kits and options (L67/L32 kits, intercoolers for higher boost levels, larger turbos, etc.) will be coming next…

Estimated lead-time is still up in the air, but our best guess is that we can start accepting pre-orders by August, and shipping by September.

INTENSEä is a Trademark of INTENSE Enterprises, Inc.
Content and Graphics Copyrightã INTENSE Enterprises, Inc 2002-2005. All Rights Reserved.
All Third Party Names, Images and Trademarks may be the property of their respective holders.
http://www.INTENSE-Racing.com
Don't make excuses. Make horsepower.