Dynamat False Knock Elimination Kit

Dynamat False Knock Elimination Kit


Part Number: DFK-100

Shipping Weight: 1.00 pounds

5 out of 55 out of 55 out of 55 out of 55 out of 5 1 Customer reviews
Read all reviews (or) Write a review

13 in stock


Share with a friend

Shipping Rate: Calculated at checkout

Eliminate false knock with this Dynamat sound deadening material kit. Three pre-cut pieces are included. The first one is used to cover a portion of the transaxle case where the planetaries, etc. are located. This is to eliminate false knock due to mechanical resonance inside the transaxle, and in close proximity to the rear knock sensor. Kudos to Steve Lipowski for the idea. The other two pieces are for the knock sensors themselves, and serve to eliminate all forms of false knock.

Average Customer Review: 5 out of 55 out of 55 out of 55 out of 55 out of 5 Based on 1 Reviews

Write a Customer Review and share your thoughts with others.

5 out of 55 out of 55 out of 55 out of 55 out of 5 Awesome kit

Alex C (Mission, Ks) 2.2.2020

I was a bit skeptical about how well this would work, but for $13 how can you go wrong? Well, all the false knock issues I was experiencing are gone, it works extraordinary well! I'd recommend this to anyone experiencing the same issues I did. It only took about 5min to install, but I already had the engine out. This would be an absolute pain to install the with engine/trans installed in the vehicle. It could probably be done but I wouldn't recommend it.

INTENSE™ and INTENSE Racing® are Trademarks of R4 Holdings, LLC. Content and Graphics © Copyright R4 Holdings, LLC 2002-2021. All Rights Reserved.
All Third Party Names, Images and Trademarks may be the property of their respective holders.

Don't make excuses. Make horsepower.